i got premier 6.5 installed on my 17inch laptop when i connected my camera via fire wire, and capture movie ,then hit record, it shows an error has occurred during capture, what do i need to do please.
in the preferences box :device control: the device is ticked at none, but when i tick dv device control2.0 it skips back to none.
[This message has been edited by johnxl1s (edited 21 May 2003).]
Hi
With everything powered off connect your camera to the computer.
Power up the camera in VTR mode.
Switch on the Mac.
Open Premiere, and go to the device control preference setting.
Do NOT touch the device control selection drop-down as it should be indicating that it has found a device - if you do touch it then Premiere gives up and stays on 'None' as you have found.
Select the appropriate camera setting in the Options list.
Open Movie Capture.....
Regards
(I dont use Premiere under OSX but I think the setup routine is the same).